Hello All,
I am excited to join this forum and group. I am currently building a Prusa Mendel and have just gotten the electronics in. I knew that this would be the point that I struggled with. I was wondering if anyone could point me in the right direction. I've gotten the software to install on my Arduino successfully and everything. I have the Pololu A4988 soldered and then installed on the ramps. Only 1 axis for now, the Z. I really haven't got a clue how to get it to move. I adjusted the pot so it was all the way counter clockwise and then 25% clockwise as an initial test spot to measure current and then I connected the motor. After connecting the motor and checking that everything was wired correctly (assuming A1 and B1 are A+ and B+ with B2 and A2 being A- and B- on the motor coils). But I get nothing from my motor. Was hoping to at least get it to lock up but it doesn't do anything. The board flashes when I hit connect in pronterface but can't get it to do anything. What can I check? I really haven't got a clue what I am doing and am not sure where to get the information. Just pointing me in the direction of a youtube video would be great. Hoping to have the electronics going pretty soon, tomorrow the printed parts should be here and I'd like to have the electronics going by tomorrow night so I can start assembly.
Any thoughts? I have looked on here. Imagine all of this is answered but I don't even know what I am looking for.
I am excited to join this forum and group. I am currently building a Prusa Mendel and have just gotten the electronics in. I knew that this would be the point that I struggled with. I was wondering if anyone could point me in the right direction. I've gotten the software to install on my Arduino successfully and everything. I have the Pololu A4988 soldered and then installed on the ramps. Only 1 axis for now, the Z. I really haven't got a clue how to get it to move. I adjusted the pot so it was all the way counter clockwise and then 25% clockwise as an initial test spot to measure current and then I connected the motor. After connecting the motor and checking that everything was wired correctly (assuming A1 and B1 are A+ and B+ with B2 and A2 being A- and B- on the motor coils). But I get nothing from my motor. Was hoping to at least get it to lock up but it doesn't do anything. The board flashes when I hit connect in pronterface but can't get it to do anything. What can I check? I really haven't got a clue what I am doing and am not sure where to get the information. Just pointing me in the direction of a youtube video would be great. Hoping to have the electronics going pretty soon, tomorrow the printed parts should be here and I'd like to have the electronics going by tomorrow night so I can start assembly.
Any thoughts? I have looked on here. Imagine all of this is answered but I don't even know what I am looking for.