Hello,
I just added a capacitive sensor and i use resistor to divide the voltage of hte output signal
Then i wired the signal to my ramps and i tested the voltage to check if it was correct, the output voltage was 3.85V which is ok for a ramps/arduino.
So i dicided to configure the firmware, but during the configuration it looks like that my ramps or my arduino broken, now it always show the Z endstop open.
I checked voltage of capacitor and it's still working.
Also it's the second time the issue appear, so i would like to know what am i doing wrong ?
Regards,
Toggy
EDIT i disabled the endstop pullup
I just added a capacitive sensor and i use resistor to divide the voltage of hte output signal
Then i wired the signal to my ramps and i tested the voltage to check if it was correct, the output voltage was 3.85V which is ok for a ramps/arduino.
So i dicided to configure the firmware, but during the configuration it looks like that my ramps or my arduino broken, now it always show the Z endstop open.
I checked voltage of capacitor and it's still working.
Also it's the second time the issue appear, so i would like to know what am i doing wrong ?
Regards,
Toggy
EDIT i disabled the endstop pullup