This is the third of my custom build and it is one that has me stumped.
The print starts out fine, screen works great, then randomly throughout the prints the LCD will display some random text(I've attached a pic). Shortly after the print stops.
The firmware is the same I run on my other two machines(with the exception of autotune values) and they work great.
I first assumed it was thermal shutdown, so I reset the pots on the ramps and they are all running under .3-.4V with nothing getting hot. I then starting replacing electronics ie Ramps/Arduino and the problem persists. The only thing left is to replace the LCD, but I'm not sure that is the issue.
Has anyone had any similar issues? I've tried searching around with no luck.
Thanks
The print starts out fine, screen works great, then randomly throughout the prints the LCD will display some random text(I've attached a pic). Shortly after the print stops.
The firmware is the same I run on my other two machines(with the exception of autotune values) and they work great.
I first assumed it was thermal shutdown, so I reset the pots on the ramps and they are all running under .3-.4V with nothing getting hot. I then starting replacing electronics ie Ramps/Arduino and the problem persists. The only thing left is to replace the LCD, but I'm not sure that is the issue.
Has anyone had any similar issues? I've tried searching around with no luck.
Thanks