Hello again
I have just wired up my velleman k8200 3d printer to run off of a ramps 1.4 and everything seems to be functioning apart from the Y axsis if I press the button to move it nudges like .01mm and the stop completey. I have checked wiring, endstops, and stepper drivers. All seem to be fine but y don't work any ideas I could try? Thanks
I have just wired up my velleman k8200 3d printer to run off of a ramps 1.4 and everything seems to be functioning apart from the Y axsis if I press the button to move it nudges like .01mm and the stop completey. I have checked wiring, endstops, and stepper drivers. All seem to be fine but y don't work any ideas I could try? Thanks