I've got a Folgertech Prusa v3 with a RAMPS board from "www.bigtree-tech.com" certainly a Chinese manufacturer. Well, I'm not sure if it died, or the Mega board died, but when I plugged it in this AM to work on the printer, nothing. No power light on the mega, and the computer wasn't even recognizing the board. Could both boards have gone bad?? If so, how can I check them?? Tried to reset the Mega with reset switch...nothing. The RAMPS reset switch doesn't do anything either.
If I have to replace one or both boards, does anyone have suggestions on a decent board??
Folgertech is out of RAMPS 1.4 boards. Are these interchangable?? Are RAMPS boards all the same?? Any help would be appreciated.
FYI, Folgertech has been very good about answering questions as I've moved through the build, but I'd like to find a few alternatives...like in this case where I can even buy a new board from them.
If I have to replace one or both boards, does anyone have suggestions on a decent board??
Folgertech is out of RAMPS 1.4 boards. Are these interchangable?? Are RAMPS boards all the same?? Any help would be appreciated.
FYI, Folgertech has been very good about answering questions as I've moved through the build, but I'd like to find a few alternatives...like in this case where I can even buy a new board from them.