Hi,
I'm new here and building my first 3D printer and I have a number of problems.
For one I am not getting any readings from the thermistors. I measured the resistance to make sure they all work and connected one of them to all three sockets. Still I am getting the MINTEMP error.
Second the y axis is not moving. I switched the motors on the x and y axis, so the stepper is okay. This might be fixable by changing the pins from E1 to Y, but that won't fly without the thermistors working.
The printer is using a Base V1.3 board which combines the Arduino Mega and RAMPS 1.4 electronics.
I fear that there might be a defect on the board, but I have no clue how to check the circuitry.
Did any of you have similar problems or have any idea how to fix these issues?
Thanks for listening to my troubles :(
I'm new here and building my first 3D printer and I have a number of problems.
For one I am not getting any readings from the thermistors. I measured the resistance to make sure they all work and connected one of them to all three sockets. Still I am getting the MINTEMP error.
Second the y axis is not moving. I switched the motors on the x and y axis, so the stepper is okay. This might be fixable by changing the pins from E1 to Y, but that won't fly without the thermistors working.
The printer is using a Base V1.3 board which combines the Arduino Mega and RAMPS 1.4 electronics.
I fear that there might be a defect on the board, but I have no clue how to check the circuitry.
Did any of you have similar problems or have any idea how to fix these issues?
Thanks for listening to my troubles :(