Hello, I am planning my first 3D printer and I was about to get mega/ramps1.4 but I am really thinking to go the 32 bit route. It's what the future of 3D printers will be, it's cheap enough (at least the clones) and so forth.
I plan to purchase them from aliexpress because it is just to wet my fingers in this 3d printing.
My question would be what should I look for the Ramps-FD (i've seen v1 vs v2 but I can't figure out which is v2 on aliexpress).
I have 2.5A stepper motors will I be able to take advantage of this power with the Ramps-FD?
What advice do you ramps-fd users have?
PS: Duet/Smoothieboard, even RADDS are out of my "1st 3d printer" options.
Thank you.
I plan to purchase them from aliexpress because it is just to wet my fingers in this 3d printing.
My question would be what should I look for the Ramps-FD (i've seen v1 vs v2 but I can't figure out which is v2 on aliexpress).
I have 2.5A stepper motors will I be able to take advantage of this power with the Ramps-FD?
What advice do you ramps-fd users have?
PS: Duet/Smoothieboard, even RADDS are out of my "1st 3d printer" options.
Thank you.