Earlier this week my bed temperatures went crazy and started showing 60ºC constantly.
At first I thought this was a bad thermistor, so I went ahead and changed to a
brand new EPCOS 100k, to my surprise it didn't make a difference. I then placed
the bed thermistor connector on T0, as opposed to the default T1, and it began
showing temperatures perfectly. My conclusion was, T1 is kaput. So, basically,
would I be able to configure Marlin 1.1 RC3 to read the bed temperatures from T2
instead of T1 (since I'm not really using T2 for anything)?
At first I thought this was a bad thermistor, so I went ahead and changed to a
brand new EPCOS 100k, to my surprise it didn't make a difference. I then placed
the bed thermistor connector on T0, as opposed to the default T1, and it began
showing temperatures perfectly. My conclusion was, T1 is kaput. So, basically,
would I be able to configure Marlin 1.1 RC3 to read the bed temperatures from T2
instead of T1 (since I'm not really using T2 for anything)?