Dear All,
I'm new to RepRap and electronics. I have connected all my boards just as schematic diagram in RepRap Wiki.
I have a LCD controller of RepRap Smart Discount Controller. The LCD lit up but there are no voltage output at D10 when I measured with my digital multimeter.
The hot end fan connected to D9 and heated bed connected to D8 having both readings of 12V output.
I uses an OEM power supply instead of ATX, feeding a 12V voltage to the RAMPS.
Can anyone please help me in troubleshooting the problem? I'm not sure which part of it goes wrong.
Thank you and hope someone can help me soon.
Regards,
Revo
I'm new to RepRap and electronics. I have connected all my boards just as schematic diagram in RepRap Wiki.
I have a LCD controller of RepRap Smart Discount Controller. The LCD lit up but there are no voltage output at D10 when I measured with my digital multimeter.
The hot end fan connected to D9 and heated bed connected to D8 having both readings of 12V output.
I uses an OEM power supply instead of ATX, feeding a 12V voltage to the RAMPS.
Can anyone please help me in troubleshooting the problem? I'm not sure which part of it goes wrong.
Thank you and hope someone can help me soon.
Regards,
Revo