Guys i need some advice as i want to build me second printer. My first one is a mendel from rpp and it was easy to build and work with . Plus the duet board with the proterface and network frindly support is something that make my life easy.
But the duet is expensive comparing to what i can find on the net ( ramps. )
So i would like to ask some things.
First i see many ramps boards. Are all of them the same ? DO i have to pay attention on possible scams ? Is there any way that ramps would support autobed leveling ? As i am building the same mendel that i bought from rpp would ramps be a problem to set it to work with this hardware setup ?
Also do you have a reliable shop for buying this board or any ebay store would do ? Finally would it be possible for ramps to run the user frindly network with web interface ?
Thanks in advance guys ,,
Be well.
But the duet is expensive comparing to what i can find on the net ( ramps. )
So i would like to ask some things.
First i see many ramps boards. Are all of them the same ? DO i have to pay attention on possible scams ? Is there any way that ramps would support autobed leveling ? As i am building the same mendel that i bought from rpp would ramps be a problem to set it to work with this hardware setup ?
Also do you have a reliable shop for buying this board or any ebay store would do ? Finally would it be possible for ramps to run the user frindly network with web interface ?
Thanks in advance guys ,,
Be well.