Hi All,
Everything was working well until the Y axis end stop unclipped. I fixed the end stop and tried again to print, but Ramps is not reading the bed temperature.
I've checked and re-soldered the bed connections, there's current flowing and the bed is heating as per normal, but the displayed temperature is hovering around the 30°C mark.
I believe that if the NTC sensor was broken then I would be getting an error, which I am not.
Any ideas?
Everything was working well until the Y axis end stop unclipped. I fixed the end stop and tried again to print, but Ramps is not reading the bed temperature.
I've checked and re-soldered the bed connections, there's current flowing and the bed is heating as per normal, but the displayed temperature is hovering around the 30°C mark.
I believe that if the NTC sensor was broken then I would be getting an error, which I am not.
Any ideas?