Printer background:
Delta printer
marlin firmware
Repetier-Host & Prontorface: software
ramps 1.4: board type
Hi everyone,
I was wondering if anyone has had a problem with the end-stops being sensed and knows how to fix it so far this is what I have tried. I at first thought I hooked them up wrong so I tried different configures but always came back to connecting up to the NC connection on my mechanical end-stop and connecting those leads to the signal (S) and ground (+) on the board. However, I still was unable to get the homing to work properly and upon more research of the functions of the ramps boardI found that I could use M119 to check the end-stops, once I did this however, I found that i was on getting information from the z end-stop or in other words got (in the return message) "z_min: open" but then nothing else I know I should be getting something from the x and y but I'm not. please let me know if there is anything you know that could help i could really use it thank for your time.
~AP
(ps. let me know if you need more information thanks again!)
Delta printer
marlin firmware
Repetier-Host & Prontorface: software
ramps 1.4: board type
Hi everyone,
I was wondering if anyone has had a problem with the end-stops being sensed and knows how to fix it so far this is what I have tried. I at first thought I hooked them up wrong so I tried different configures but always came back to connecting up to the NC connection on my mechanical end-stop and connecting those leads to the signal (S) and ground (+) on the board. However, I still was unable to get the homing to work properly and upon more research of the functions of the ramps boardI found that I could use M119 to check the end-stops, once I did this however, I found that i was on getting information from the z end-stop or in other words got (in the return message) "z_min: open" but then nothing else I know I should be getting something from the x and y but I'm not. please let me know if there is anything you know that could help i could really use it thank for your time.
~AP
(ps. let me know if you need more information thanks again!)