After installing the E3D hotend and configuring of Marlin firmware I am getting strange behavior on the thermistor reading.
It heats up untill 50-60 *C and after it shoots through the roof and MAXTEMP is reached. Shows a number like 410 *C. But the hotend is not that hot.
Could the thermistor be faulty? Or am I misconfiguring something..
Sending the command: M303 also gives the MAXTEMP error.
It heats up untill 50-60 *C and after it shoots through the roof and MAXTEMP is reached. Shows a number like 410 *C. But the hotend is not that hot.
Could the thermistor be faulty? Or am I misconfiguring something..
Sending the command: M303 also gives the MAXTEMP error.