Hi everybody. This is my first post to the Reprap-forum.
I bought my printerkit off Aliexpress in september last year. It was a prusa I3. Unfortunately it was one of those troublesome kits with lots of problems, and I have yet to get even a single acceptable print off it.
I havent given up quite yet, and It's getting better every week it seems, however I have encountered one problem which I cannot seem to figure out. Additionally - I havent found any other person that has had this problem and written about it yet, so...
Whats left on my printer is the endstops. They are all connected, and it seems to me like its properly connected as well(I could be wrong ofc) - However when the carriage reaches the endstops the entire printer turns off. The only endstop that is actually working properly is the Z-axis. What am I doing wrong? This seem to me like it's probably got something to do with the marlin settings rather than the wiring? Am I right?
Anybody encountered this before?
I bought my printerkit off Aliexpress in september last year. It was a prusa I3. Unfortunately it was one of those troublesome kits with lots of problems, and I have yet to get even a single acceptable print off it.
I havent given up quite yet, and It's getting better every week it seems, however I have encountered one problem which I cannot seem to figure out. Additionally - I havent found any other person that has had this problem and written about it yet, so...
Whats left on my printer is the endstops. They are all connected, and it seems to me like its properly connected as well(I could be wrong ofc) - However when the carriage reaches the endstops the entire printer turns off. The only endstop that is actually working properly is the Z-axis. What am I doing wrong? This seem to me like it's probably got something to do with the marlin settings rather than the wiring? Am I right?
Anybody encountered this before?