Ok, I have been at this for months and I have come to a point where I have no idea what to do next. I have a Prusa I3 (GEEETech) Ramps 1.4. Everything seems to work fine except every single motor. I could really use some help. From the searching I have found these symptoms are relevant:
Heatbed and printhead work perfectly.
Motors: No movement or noise. Motors have some resistance to manual movement but not much.
I have triple checked my wiring to realise I am not 100% sure exactly how it should be assembled. I have tried everything I can think of but I am now at a loss. Thanks for your time. As for now, I am going to bed. Hopefully some good info in the morning. If you need any info, please ask.
Heatbed and printhead work perfectly.
Motors: No movement or noise. Motors have some resistance to manual movement but not much.
I have triple checked my wiring to realise I am not 100% sure exactly how it should be assembled. I have tried everything I can think of but I am now at a loss. Thanks for your time. As for now, I am going to bed. Hopefully some good info in the morning. If you need any info, please ask.