I followed a couple of YouTube guides to get my inductive proximity sensor that came with the Folgertech kit wired. The light correctly turns on in proximity to aluminum and turns off when not in proximity. The issue now is when I run an M119 protocol, the sensor is always reported as triggered and does not toggle. I know I can reverse the logic but the problem here is the toggling,not the triggered specifically.
I followed a few threads and they all talk about a fried RAMPS or Mega pin. I've swapped both pieces and am still getting the same problem.I do not know if it's still a RAMPS issue or a wiring issue. My sensor is NPN for reference. I connected the brown wire to Vline and the rest is iffy.I used a voltage divider to shoot the current to ground but am not getting the desired result.
I followed a few threads and they all talk about a fried RAMPS or Mega pin. I've swapped both pieces and am still getting the same problem.I do not know if it's still a RAMPS issue or a wiring issue. My sensor is NPN for reference. I connected the brown wire to Vline and the rest is iffy.I used a voltage divider to shoot the current to ground but am not getting the desired result.