Hi there,
i have RAMPS 1.4 and my heatbed fails.
Set heatbed to 70°C and measuring the current from the bed = 10V until it fails somewhere around 60°C to 0.19V.
I'm suspecting the Polyfuse and would like to replace both of them.
Anyone know how many amps should the blade fuse hold?
Anyone know any solder type blade fuse connectors for PCB? (as a direct replacement)
(Both thermistors are sitting in their holes and reporting room temperature after cooling down. PSU reads 12.5V constant)
i have RAMPS 1.4 and my heatbed fails.
Set heatbed to 70°C and measuring the current from the bed = 10V until it fails somewhere around 60°C to 0.19V.
I'm suspecting the Polyfuse and would like to replace both of them.
Anyone know how many amps should the blade fuse hold?
Anyone know any solder type blade fuse connectors for PCB? (as a direct replacement)
(Both thermistors are sitting in their holes and reporting room temperature after cooling down. PSU reads 12.5V constant)