I am using a z probe for bed leveling using the G29 command.
Whenever I try to move the Z steppers with the G1 Z10 command, it moves without an issue. Same with any other value such as G1 Z0.01.
When I run G29, the stepper make a loud noise, but don't move at all (I have removed both steppers from the lead screws to see if they would work without a load, but I am getting the same results)
I am using Marlin and Repetier host
Whenever I try to move the Z steppers with the G1 Z10 command, it moves without an issue. Same with any other value such as G1 Z0.01.
When I run G29, the stepper make a loud noise, but don't move at all (I have removed both steppers from the lead screws to see if they would work without a load, but I am getting the same results)
I am using Marlin and Repetier host