Hey guys,
I'm helping out a friend with his 3D printer. Everything is connected and the right firmware is uploaded. We wanted to connect the printer to repetier and we instantly got a MAXTEMP ERROR.
The bed and the hot end are both reading 120-130°C, while just at room temperature. I was first thinking this was a connection error or a short in the board or thermistor. But when trying to disconnect and connect again from Repetier it suddenly had good readings, wich than suddenly raised up again and again receiving a maxtemp error. I don't know what it causes. Anyone here that has experience with it?
Thanks,
Andreas
I'm helping out a friend with his 3D printer. Everything is connected and the right firmware is uploaded. We wanted to connect the printer to repetier and we instantly got a MAXTEMP ERROR.
The bed and the hot end are both reading 120-130°C, while just at room temperature. I was first thinking this was a connection error or a short in the board or thermistor. But when trying to disconnect and connect again from Repetier it suddenly had good readings, wich than suddenly raised up again and again receiving a maxtemp error. I don't know what it causes. Anyone here that has experience with it?
Thanks,
Andreas