Hello ramps helprs,
I have a prablmo with TEMP reading on the ramps the temperature reading is stuck on a number I check the thermistor's both fine so Iam guessing I short some thing.
my mk2 hetedbed have couple of copper wires that were flash out by the movement of the platform and on top is a aluminum board so i think that the nozzle touch the aluminum board and close a loop some were? and one more thing my frame is acrylic.
so any one had this problem before if so can any thing can be done to save the ramps?
I have a prablmo with TEMP reading on the ramps the temperature reading is stuck on a number I check the thermistor's both fine so Iam guessing I short some thing.
my mk2 hetedbed have couple of copper wires that were flash out by the movement of the platform and on top is a aluminum board so i think that the nozzle touch the aluminum board and close a loop some were? and one more thing my frame is acrylic.
so any one had this problem before if so can any thing can be done to save the ramps?