Hello I finally got all my electronics in the mail today and have been working all day to get my first print started. I built my own printer and I am using Ramps 1.4 on a Mega. I have the large LCD smart controller and the MK8 Extruder. I have everything up and running and have verified that everything works. However, when I try to run a print using Universal GCode Sender it does not start the print. I looked at the command list and see that the command to heat up was sent but my heater does not start up. I can see the temperatue on my smart controller does not rise. I am able to use my smart controller to directly preheat my hot end so I know it is most probably some kind of software issue. Any help would be greatly appreciated I am mentally running out of steam but really want to get it running today. Thanks in advance!
↧