I'm having a problem with a melzi board replacement. My old board was garbage from the manufacturer so I had to purchase my own. Upon the new board coming, the 3 prong terminals have been replaced by 2 prong terminals for the endstops. How do I connect a 3 wire endstop to a 2 wire terminal? Is there any way? I have a VCC, ground and signal coming from the endstop and the board only has 2 connections for each endstop.
So is there a way to make this happen or do I have to just buy new analog endstops instead? I would appreciate info anyone could offer on this. Thanks.
So is there a way to make this happen or do I have to just buy new analog endstops instead? I would appreciate info anyone could offer on this. Thanks.