I recently made some upgrades to my printer. I upgraded the lead screws and motors. I am very happy with the results! Might sound excessive but I think I increased my potential prints speeds by about 8X! I aiming to be one of the fastest non belt driven printers :D. Sadly I haven't been able to really open it up because I am having a frustrating and confusing problem I cannot figure out. I didn't change much in the configuration after the upgrades but for some reason when the auto bed leveling starts the X and Y (mostly X) shoots forward real fast and take a measurement and then slows down to normal probing speeds and finishes. But, by that time everything is messed up because I watch the next reading and it will say it is at x0 and y0 but its about 50mm past that. So, it completely throws off everything. I cannot figure it out. If anyone has any ideas or advice please let me know.
↧