running 34nema motors from ramp 1.4 sprinter pronterface (3 replies)

Hi
Im having trouble getting one motor to spin using arduino and sprinter and pronterface i have the small extruder motor connected and its working ive tried different wiring setups and change the steps in sprinter ****any help would be apprieciated ******here are some pics******* the black motor wire is attched to a yellow motor wire

1 MA860H Stepper Motor Driver Max 80VAC or 110VDC with 2.4-7.2A
1 Dual Shaft Nema 34 CNC Stepper Motor 8.5Nm(1204oz.in) 34HS46-5004D
1 Switching Power Supply 350W 60V 5.9A for CNC Router Kits 115V/230V S-350-60

Stepper Motor 34HS46-5004D

Manufacturer Part Number 34HS46-5004D
Motor Type Bipolar Stepper
Step Angle 1.8°
Holding Torque 8.5Nm(1204oz.in)
Rated Current/phase 5.0A
Phase Resistance 1.0ohms
Recommended Voltage 24-60V


Stepper Driver MA860H

High performance, cost-effective
Supply voltage up to 80VAC or +110VDC
Output current up to 7.2A
Pulse input frequency up to 300 KHz
16 selectable resolutions in decimal and binary, up to 51,200 steps/rev
Suitable for 2-phase and 4-phase motors

MA860H driver

Max.
Unit
Output Current
2.6
-
7.2(5.1RMS)
A
Supply Voltage
18
60
80
VAC
+24
+80
+110




Model S-350-60
DC Output 60V 5.9A
Adjustable range for DC Voltage 54.5V~67V
AC Input Voltage 93~132V/176~264VAC Slected by Switch
AC Input Current 3.6A/115VAC 1.8A/230VAC

The black wire comming from the driver is attached to the yellow motor wire
I think ive got the wiring right,,,, but not sure about changes in sprinter firmware any help would be appreiciated