Hello,
My Z-axis motor is not moving when I run the RAMPS 1.4 test code. I have verified that the motor drivers are not the cause. I have also used a multimeter to check the voltages coming out of the DIR, STEP and VMOT pins. When comparing the voltages from these pins on the Z and X axes (which works), they are identical. Any suggestions would be much appreciated.
My Z-axis motor is not moving when I run the RAMPS 1.4 test code. I have verified that the motor drivers are not the cause. I have also used a multimeter to check the voltages coming out of the DIR, STEP and VMOT pins. When comparing the voltages from these pins on the Z and X axes (which works), they are identical. Any suggestions would be much appreciated.