USE_XMIN_PLUG inop... (no replies)

Changing over from Melzi to Mega 2560 with Ramps 1.4.

In testing I find the that XMIN_PLUG is not showing properly when I do M119. The Y_MIN_PLUG AND Z_MIN_PLUG are functioning properly. The X_MAX_PLUG is working.

Using Marlin Firmware (latest).

I've had the vendor dispatch another Ramps board but it is going to be at least 7 days before it gets here.

Is there a way in Marlin to have the software to use XMAX_PLUG in the place of X_MIN_PLUG. The X axis motor will not run if the X_MIN_PLUG limit not seen.

Please advise...