Brand new Folgertech Pusa 2020 I3. Finished build, downloaded Repetier and Arduino software onto computer. If I just plug the printer in, the Ramps board and the Arduino have no lights illuminated, but the power supply has the green LED illuminated. If I plug in the USB, the Rams has orange light that flashes and I can see the green LED illuminate for the Arduino. The LCD will also power on, but no writing just blocks and blue screen.
The printer does not respond to anything in Repetier in manual mode. No heat at heat bed, not heat at extruder, no motor movement or noise.
Very frustrated because my 14yr old can't use his gift. I'm not a programmer by any means and I wouldn't expect the electronics to be bad out of the box.
I am mechanically inclined and made sure steps were followed closely for the build.
Any help would be appreciated.
The printer does not respond to anything in Repetier in manual mode. No heat at heat bed, not heat at extruder, no motor movement or noise.
Very frustrated because my 14yr old can't use his gift. I'm not a programmer by any means and I wouldn't expect the electronics to be bad out of the box.
I am mechanically inclined and made sure steps were followed closely for the build.
Any help would be appreciated.