dual extruders on Ramps 1.4, only E0 is working. (4 replies)

Hi
Have 2 extruders connected to my Ramps 1.4. Only that one on E0 is working. If I shift the Cables extruder 2 works when connected to E0.
I have replaced the stepper drivers without any luck..
I have the same configuration on both extruders made in Repetier configurator 0,92.
I use M302 S1 for Cold extrusion.
Is there someone with a solution for this?
Is there any jumpers or settings that I HAVE missed?
I can se both extruders, heaters and temp sensor working in Repetier Host.
I have attecded the full software.
BR