Hey there
I just switched my X and Y stepper motor drivers from A4988 to TMC2100. But now I experience layer shifting (only in Y direction).
- I set the TMC drivers to spreadCycle Mode
- I set the motor current first to 0.7 A which was what the A4988 were set to
Then I got layer shifting and therefore set it to 1 A and reduced the Acceleration to 1000mm/s^2 (2000 max) and jerk to 10
The motor is getting pretty hot now (55°C) but I stil have layer shifting.
What can I do now?
I just switched my X and Y stepper motor drivers from A4988 to TMC2100. But now I experience layer shifting (only in Y direction).
- I set the TMC drivers to spreadCycle Mode
- I set the motor current first to 0.7 A which was what the A4988 were set to
Then I got layer shifting and therefore set it to 1 A and reduced the Acceleration to 1000mm/s^2 (2000 max) and jerk to 10
The motor is getting pretty hot now (55°C) but I stil have layer shifting.
What can I do now?