HELP ME guys for my homemade 3D printer. I am stucked at the final stage.
When I connect my Ardiuno bord alone to my laptop it is working fine (i think so) and I am able to upload the marlin firmware to it succesfully. (COM PORT 8)
BUT, When the Ardiuno is connected along with RAMPS 1.4 to my laptop + Power Sorce (12V ,20A), no recognition and sometimes giving error messege of POWER SURGE ON HUB PORT. HOWEVER, endstops are working.
note:
Ramps bord is fully assembled with all stepper motor drivers and other wirings too.
I am using win7.
Please let me know if anybody have faced same issue or any ideas how to resolve this issue.
When I connect my Ardiuno bord alone to my laptop it is working fine (i think so) and I am able to upload the marlin firmware to it succesfully. (COM PORT 8)
BUT, When the Ardiuno is connected along with RAMPS 1.4 to my laptop + Power Sorce (12V ,20A), no recognition and sometimes giving error messege of POWER SURGE ON HUB PORT. HOWEVER, endstops are working.
note:
Ramps bord is fully assembled with all stepper motor drivers and other wirings too.
I am using win7.
Please let me know if anybody have faced same issue or any ideas how to resolve this issue.