When I started tuning the drv8825, I was going for about 0.8V, but one of the drivers there was something wrong with the potentiometer, because when I had a reading of 0.3V and turned half a milimiter it went up to 1.5V (really) and after a very long time I got to about 0.82V, my worries is, when I start printing, because of the vibrations the screw is probably going to make the potentiometer change its voltage a bit, and because it is so sensible it may go up too high, is there any danger on a too high voltage drv? What could happen?
↧