Hello
I am trying to connect a 3d touch sensor to ramps 1.4 as per geeetech instructions. It looks like there is no power (5V) going to the 3d Touch. The board seems to be working ok. Any ideas ?
The ramps is powered up using the Original Geeetech power supply 12V DC/ 20A
Thank you
I am trying to connect a 3d touch sensor to ramps 1.4 as per geeetech instructions. It looks like there is no power (5V) going to the 3d Touch. The board seems to be working ok. Any ideas ?
The ramps is powered up using the Original Geeetech power supply 12V DC/ 20A
Thank you