The RAMPS 1.4 board has been used very successfully for many years now, but it seems to me that it might be time for an upgrade to the design.
Will be okay to ask in this forum location, about what people most want from a upgraded design of the RAMPS board?
Among my own wishes are:
- to make it much easier to use TMC2130 drivers. Like I would want it to be as simple as moving some jumpers.
- to have better connectors (and a better mosfet) for the heat-bed, so it would be possible to operate some of those 30x30cm heat-beds that are available these days.
- an easy path to run heat-bed and/or steppers at 24V volts.
- an easy way to chose between using the RAMPS board on an Arduino Mega or Arduino Due
What are some of your experiences (both good or bad) with the RAMPS board?
Will be okay to ask in this forum location, about what people most want from a upgraded design of the RAMPS board?
Among my own wishes are:
- to make it much easier to use TMC2130 drivers. Like I would want it to be as simple as moving some jumpers.
- to have better connectors (and a better mosfet) for the heat-bed, so it would be possible to operate some of those 30x30cm heat-beds that are available these days.
- an easy path to run heat-bed and/or steppers at 24V volts.
- an easy way to chose between using the RAMPS board on an Arduino Mega or Arduino Due
What are some of your experiences (both good or bad) with the RAMPS board?