I'm having a rough time with getting my machine to read from an SD card.
It's a Ramps 1.4 shield on an Elegoo MEGA 2560 R3 board, using a RepRapDiscount Smart Controller LCD/SD Combo (model 2004a).
I've got the display to work, I can navigate fine, everything was going smoothly until I tried my SD card slot. I'd enabled ' #define REPRAP_DISCOUNT_SMART_CONTROLLER ' and ' #define SDSUPPORT', as well as '#define SDCARD_CONNECTION LCD'.
The LCD shows "Media Inserted" when I put the card in, and "Media removed" when I take it out. But when I'm in the menu, it shows "No Media". I've tried four different SD cards, all formatted both FAT and FAT32 with two gcode files in the base directory. Same deal.
I tried '#define SPI_SPEED SPI_HALF_SPEED', as well as quarter, and 1/8th speeds. I also tried multiple IDC cables, reseated the controller board, even ordered another LCD from another seller. Same issue persists.
What else could I try?
Configuration.h - [pastebin.com]
Configuration_adv.h - [pastebin.com]
It's a Ramps 1.4 shield on an Elegoo MEGA 2560 R3 board, using a RepRapDiscount Smart Controller LCD/SD Combo (model 2004a).
I've got the display to work, I can navigate fine, everything was going smoothly until I tried my SD card slot. I'd enabled ' #define REPRAP_DISCOUNT_SMART_CONTROLLER ' and ' #define SDSUPPORT', as well as '#define SDCARD_CONNECTION LCD'.
The LCD shows "Media Inserted" when I put the card in, and "Media removed" when I take it out. But when I'm in the menu, it shows "No Media". I've tried four different SD cards, all formatted both FAT and FAT32 with two gcode files in the base directory. Same deal.
I tried '#define SPI_SPEED SPI_HALF_SPEED', as well as quarter, and 1/8th speeds. I also tried multiple IDC cables, reseated the controller board, even ordered another LCD from another seller. Same issue persists.
What else could I try?
Configuration.h - [pastebin.com]
Configuration_adv.h - [pastebin.com]