So I have this printer for awhile now (from Kickstarter) and one of the component just quit and I don't know where to start to diagnosis the problem. It's a Rigidbot Big that is running a board based on Arduino Mega2560 & RAMPS 1.4. Not sure what the problem is (short circuit?) but Cura is reading a very high number whether the heated bed wires are plugged in or not at 358° degrees C.
- I have tried replacing the wires that connect from the board to the heated bed.
- Also did a continuity test but I don't know what I am looking for. Pin 2 seems to connect to,4,6,8,10,9 and shows a reading. When I connect pin 2 to 1,3,5,7, the red led light up on the board but no reading so I don't know what all these mean...
- I tried using Pronterface but it also show really high setting.
Link to Wiki:
[rigidwiki.com]
- I have tried replacing the wires that connect from the board to the heated bed.
- Also did a continuity test but I don't know what I am looking for. Pin 2 seems to connect to,4,6,8,10,9 and shows a reading. When I connect pin 2 to 1,3,5,7, the red led light up on the board but no reading so I don't know what all these mean...
- I tried using Pronterface but it also show really high setting.
Link to Wiki:
[rigidwiki.com]