Hi all,
I recently melt a ramps 1.4 build in mosfet by trying to heat a Mk2B heatbed to 110 degrees, so I decided to get an external mosfet.
I'm kind of new to 3d printing but I watched a lot of youtube videos showing how to set this up.
Now, with the external mosfet I burned out the wire that comes from D8 to the mosfet Control in.
Everything works just fine without the external mosfet, but I don't want to burn anything else.
I don't know what I'm missing, if anyone can help I would be grateful.
I recently melt a ramps 1.4 build in mosfet by trying to heat a Mk2B heatbed to 110 degrees, so I decided to get an external mosfet.
I'm kind of new to 3d printing but I watched a lot of youtube videos showing how to set this up.
Now, with the external mosfet I burned out the wire that comes from D8 to the mosfet Control in.
Everything works just fine without the external mosfet, but I don't want to burn anything else.
I don't know what I'm missing, if anyone can help I would be grateful.