Hello all,
I have a Chinese version TMC2130 v1.1. It works in SPI mode without any hardware action. I can read data using M122 and update them. But I have problems with Stall Detection. So, I thought that I have to solder CFG4 to GND and CFG5 to VCC but while I was trying to solder those tiny pins, I screwed up. I think soldering iron is too hot for these soldering flanges or I am not good enough.
Is there any other way that does not need any soldering for TMC2130 Stall detection configuration?
I have a Chinese version TMC2130 v1.1. It works in SPI mode without any hardware action. I can read data using M122 and update them. But I have problems with Stall Detection. So, I thought that I have to solder CFG4 to GND and CFG5 to VCC but while I was trying to solder those tiny pins, I screwed up. I think soldering iron is too hot for these soldering flanges or I am not good enough.
Is there any other way that does not need any soldering for TMC2130 Stall detection configuration?