How can I put it ? I print the 20mm tryout printing cube , its perfect , no faults and looks great , I try to print a new hotend fan holder from Thingiverse and the layers are rough like a file on the surface.I have tried all types of tempertures , filament speeds all to no avail . I have never had problems like this before , lucky i suppose !! So settings are 230 hotend 0,4 nozzle and normally press start and always a perfect print . So question was is it the new PLA I have just bought ? Nope I had some left from the old roll same result. Reset Simplify to works original settings just in case , its the same . Any ideas out ther ? Hope so .
↧