Hey everyone I have already asked this question on the official NI forum and haven't gotten a reply yet, so I'm posting here to see if someone can help me with this.
I want to control Ramps 1.4 and move the X servo motor through LabView using the Hobbyist toolbox but I'm getting the 5005 error stating that Digital input channel 54 is not available as Arduino mega only supports up to channel 53 (see attachment for the error message). Is there any way to solve this problem?
I want to control Ramps 1.4 and move the X servo motor through LabView using the Hobbyist toolbox but I'm getting the 5005 error stating that Digital input channel 54 is not available as Arduino mega only supports up to channel 53 (see attachment for the error message). Is there any way to solve this problem?