Background
- Im a newbe using arduino, ramps 1.4, mandel max setup running marlin and pronteface.
Just got my x axis, y axis, z axis moving, my hot end heating and my hotend temperature sensor sencing. Brilliant.
- Then just bridged something on hall-o endstops while just doing a final tightening and something (i belive on my ramps 1.4/arduino) went pop. I shut everything down and restarted 5 mins later.
Problem
- Everything is working as it once was, as are the endstops. However the temperature is reading between ~478-499 on proteface and the hothead not heating (presumably because of the temperature reading).
Question to the forum
- Can anyone provide advice +/- minimal abuse for the shameful act of not turning it all off while adjusting
Thanks in advance,
Kramma
- Im a newbe using arduino, ramps 1.4, mandel max setup running marlin and pronteface.
Just got my x axis, y axis, z axis moving, my hot end heating and my hotend temperature sensor sencing. Brilliant.
- Then just bridged something on hall-o endstops while just doing a final tightening and something (i belive on my ramps 1.4/arduino) went pop. I shut everything down and restarted 5 mins later.
Problem
- Everything is working as it once was, as are the endstops. However the temperature is reading between ~478-499 on proteface and the hothead not heating (presumably because of the temperature reading).
Question to the forum
- Can anyone provide advice +/- minimal abuse for the shameful act of not turning it all off while adjusting
Thanks in advance,
Kramma