Hello there!
First of all i want to thank the forum and all the people because i have learn a lot with it.
I´m thinking coming in in the RepRap 3D printing and i was thinking building a Prusa i3.
I have a question regarding the best electronics, i see that most everyone use RAMPS 1.4 but it seems that Megatronics 2.0 is the news version of it, cheaper, smaller and with more features. The problem is that support , new firmware to Megatronics 2.0 is almost ZERO, i understand that Meg. 2.0 is a version of RAMPS 1.4 but it have some differences.
What do you recommend i should acquire, regarding all aspect of both electronics, i love the all in one board from megatronics but the firmware updating and support for RAMPS 1.4 seems much better.
Thank you for your attention.
Regards
First of all i want to thank the forum and all the people because i have learn a lot with it.
I´m thinking coming in in the RepRap 3D printing and i was thinking building a Prusa i3.
I have a question regarding the best electronics, i see that most everyone use RAMPS 1.4 but it seems that Megatronics 2.0 is the news version of it, cheaper, smaller and with more features. The problem is that support , new firmware to Megatronics 2.0 is almost ZERO, i understand that Meg. 2.0 is a version of RAMPS 1.4 but it have some differences.
What do you recommend i should acquire, regarding all aspect of both electronics, i love the all in one board from megatronics but the firmware updating and support for RAMPS 1.4 seems much better.
Thank you for your attention.
Regards