I am not sure if I am hearing things or if I createda radio curcuit, but I can swear I heard the radio playing on my stepper motor.
I had just started to fine tune my z axis pot.
following the wiki article
(http://reprap.org/wiki/Pololu_stepper_driver_board)
being anxious to fine tune my printer;
I first set it high (max)
the lowered it.
then I went to check the reading on the multimeter, however
I did not turn the multimeter on, and had only touched the pot
this is when I could have sworn the radio was playing.
after I removed the red probe never touching the black probe it stopped,
I measured and it said .32##
is this even possible? or am I spending too much tiem on my printer
I had just started to fine tune my z axis pot.
following the wiki article
(http://reprap.org/wiki/Pololu_stepper_driver_board)
being anxious to fine tune my printer;
I first set it high (max)
the lowered it.
then I went to check the reading on the multimeter, however
I did not turn the multimeter on, and had only touched the pot
this is when I could have sworn the radio was playing.
after I removed the red probe never touching the black probe it stopped,
I measured and it said .32##
is this even possible? or am I spending too much tiem on my printer