Good Afternoon!
I built a Mendel90 from a kit from Nophead, and it is using Melzi electronics. I am using Slic3r to generate gcode files and using Pronterface to operate my printer.
What I am noticing is that occasionally the printer offsets one axis slightly during a layer change. (Picture of this issue is attached) This has occurred on multiple design files, and operating Pronterface on multiple computers has resulted in the same problem. It seems fairly random, but the offset always occurs on a layer change.
Have anyone else seen this type of thing before? I suspect it to be on the data side of the electronics and not mechanical, but I can't be sure.
Thanks!
Matt
I built a Mendel90 from a kit from Nophead, and it is using Melzi electronics. I am using Slic3r to generate gcode files and using Pronterface to operate my printer.
What I am noticing is that occasionally the printer offsets one axis slightly during a layer change. (Picture of this issue is attached) This has occurred on multiple design files, and operating Pronterface on multiple computers has resulted in the same problem. It seems fairly random, but the offset always occurs on a layer change.
Have anyone else seen this type of thing before? I suspect it to be on the data side of the electronics and not mechanical, but I can't be sure.
Thanks!
Matt