I just need clarification before I get in too deep with what I have going on.
I was given quite a few NEMA 23 motors. They are 1.8* steps, 12V and either .42A or .68A. These motors also have 6 wires coming from them.
Could I make a 3D printer using these steppers with the RAMPS 1.4 board with Pololu A4988 drivers? They state that they can do 2A per coil.
Is it even worth the headache using the larger motors or should I just stick with NEMA 17's like everyone else.
Thanks all!
I was given quite a few NEMA 23 motors. They are 1.8* steps, 12V and either .42A or .68A. These motors also have 6 wires coming from them.
Could I make a 3D printer using these steppers with the RAMPS 1.4 board with Pololu A4988 drivers? They state that they can do 2A per coil.
Is it even worth the headache using the larger motors or should I just stick with NEMA 17's like everyone else.
Thanks all!