I am trying to print some calibration files but the power supply shuts down in mid print every time. Restarting it causes the print to continue but with the coordinates thrown off by centimeters, any ideas what can be wrong?
I have a 500W ATX supply with a breakout board: [www.2printbeta.de]
It is powering a RAMPS 1.3
The stops can occur anytime during the print and even several times during the same print.
I have a 500W ATX supply with a breakout board: [www.2printbeta.de]
It is powering a RAMPS 1.3
The stops can occur anytime during the print and even several times during the same print.