Hello,
I recently built a Mendel i2 and unfortunately the wires for my fan (going into D9) came into contact with the wires for my heated bed (D8) and it partially melted. I caught it before it got toooo bad, but now when I go to use my heated bed it will heat up to about 100 C and then cool off. Do you know what could be causing that? Could I fix it by going into the firmware and making the D9 connection be for the heated bed? If so, where in the code would I be able to do that? I attached a picture of what the connection now looks like. Thank you!
I recently built a Mendel i2 and unfortunately the wires for my fan (going into D9) came into contact with the wires for my heated bed (D8) and it partially melted. I caught it before it got toooo bad, but now when I go to use my heated bed it will heat up to about 100 C and then cool off. Do you know what could be causing that? Could I fix it by going into the firmware and making the D9 connection be for the heated bed? If so, where in the code would I be able to do that? I attached a picture of what the connection now looks like. Thank you!