Hi Everyone,
I'd like to hear opinion on what is the optimal minimum distance from the bed to the nozzle. Right now, using Pronterface, I measured 120.80 mm from home to just holding a piece of paper in place - I can slide the paper with noticeable drag. Not enough pressure to score the paper when I slide it around under the nozzle.
My calipers say the paper is 0.107mm (0.00425in) thick.
So, what is your set at?
THX!
Oh, and my nozzle is a Mk V-BV 0.35mm (new to the printer; my Christmas present)
- a -
I'd like to hear opinion on what is the optimal minimum distance from the bed to the nozzle. Right now, using Pronterface, I measured 120.80 mm from home to just holding a piece of paper in place - I can slide the paper with noticeable drag. Not enough pressure to score the paper when I slide it around under the nozzle.
My calipers say the paper is 0.107mm (0.00425in) thick.
So, what is your set at?
THX!
Oh, and my nozzle is a Mk V-BV 0.35mm (new to the printer; my Christmas present)
- a -