Hi all,
I have some servo motors that I would like to use for a 3d printer, the man who designed them has specified that in order to accomplish this, I need to wire them to the step/direction commands coming from the atmel, before the driver. These motors will be powered via a common hub, and feature eeprom/driver chips. I have ordered a sainsmart ramps 1.4, but due to either bad documentation, or my obvious lack of experience with electronics, I have been unable to figure out where I need to connect the motors to. Any feedback would be appreciated, please keep in mind that I am not terribly familiar with electronics in general.
I have some servo motors that I would like to use for a 3d printer, the man who designed them has specified that in order to accomplish this, I need to wire them to the step/direction commands coming from the atmel, before the driver. These motors will be powered via a common hub, and feature eeprom/driver chips. I have ordered a sainsmart ramps 1.4, but due to either bad documentation, or my obvious lack of experience with electronics, I have been unable to figure out where I need to connect the motors to. Any feedback would be appreciated, please keep in mind that I am not terribly familiar with electronics in general.