Hey guys...
Me and the kids are wanting to build our first 3D printer, however i was originally going to build a DIY CNC so I have some stuff left over from that.
I already have quite a bit of stuff that accumulated towards a DIY CNC Mill so might as well put it to use!
I have 4x Applied Motion STM23Q-3AE
Yes I know... Its complete overkill, but I have it sitting here collecting dust so why not actually put it to use!
As you can see the motor already has a driver built in but it can run on either step by step or SCL
SCL would be nice as it would reduce the amount of wiring required and since the units are programable its and easy to implement with a use of their 4 or 8 port router/switch boards...
Input please !!
Me and the kids are wanting to build our first 3D printer, however i was originally going to build a DIY CNC so I have some stuff left over from that.
I already have quite a bit of stuff that accumulated towards a DIY CNC Mill so might as well put it to use!
I have 4x Applied Motion STM23Q-3AE
Yes I know... Its complete overkill, but I have it sitting here collecting dust so why not actually put it to use!
As you can see the motor already has a driver built in but it can run on either step by step or SCL
SCL would be nice as it would reduce the amount of wiring required and since the units are programable its and easy to implement with a use of their 4 or 8 port router/switch boards...
Input please !!