Hello,
I got a Saint Smart kit Arduino 2560 R3 + Ramps 1.4, but I am having all sorts of problems...
To test my hardware I uploaded the Ramps test Firmware: ( [reprap.org] ) and it moves the stepper motors, but it is in an endless loop that I can't stop!!!!
I try to upload a new firmware to delete the Ramps Test firmware but I can't it shows this message:
How can I make it stop from executing the test firmware?
Does this mean that the hardware I have is broken?
My set up: Win 7, Arduino IDE 1,05 and 0023, I have set in Arduino IDE , Tools the right board and selected the correct COM port.
I would appreciate your help a lot.
I got a Saint Smart kit Arduino 2560 R3 + Ramps 1.4, but I am having all sorts of problems...
To test my hardware I uploaded the Ramps test Firmware: ( [reprap.org] ) and it moves the stepper motors, but it is in an endless loop that I can't stop!!!!
I try to upload a new firmware to delete the Ramps Test firmware but I can't it shows this message:
How can I make it stop from executing the test firmware?
Does this mean that the hardware I have is broken?
My set up: Win 7, Arduino IDE 1,05 and 0023, I have set in Arduino IDE , Tools the right board and selected the correct COM port.
I would appreciate your help a lot.